微波消解—火焰原子吸收分光光度法测定土壤中的钴、钼

土壤样品的传统消解方法是用电热板硝酸-氢氟酸-高氯酸体系,消解时间长,试剂用量大,对操作人员身体危害大,并且测定结果也不准确。本文阐述了微波消解——原子吸收分光光度法测定土壤中的钴、钼。通过硝酸-盐酸-氢氟酸-高氯酸消解体系,选择出微波消解的最佳消解条件,通过对微波消解体系和传统消解体系进行对比试验,微波消解体系具有赶酸时间短,准确度高,对人体危害小,是一种值得推广的土壤消解方法。     

微波消解-火焰原子吸收分光光度法测定固体废物中的钡

采用微波消解法对固体废物浸出液样品进行前处理,采用乙炔-空气火焰原子吸收法测定钡的含量,检出限为2．04mg／L,加标回收率为94．5％,精密度为4．85％-6．81％。     

节水灌溉与控释肥施用对太湖地区稻田土壤氮素渗漏流失的影响

在太湖流域采用田间小区试验研究了干湿交替节水灌溉与控释肥(控释BB肥与树脂包膜尿素)施用对稻田30 cm深土壤渗漏水总氮(TN)、铵态氮(NH+4-N)、硝态氮(NO-3-N)和亚硝态氮(NO-2-N)浓度的动态变化及氮素淋失的影响.结果表明:各处理渗漏水TN、NH+4-N和NO-2-N浓度均在施肥后10 d内达到高峰,然后逐渐下降.渗漏水氮素以NH+4-N(0.22~15.15 mg·L-1)为主,平均占TN 70.1%,NO-3-N(0.10~0.95 mg·L-1)占TN比例较低,平均为13.0%,NO-2-N(0~0.24 mg·L-1)平均仅占TN 1.3%.与淹灌相比,节灌对稻田渗漏水氮素浓度及各氮素占总氮的比例影响不大,但降低了14.2%的渗漏水量和9.4%的TN淋失量.施氮显著提高了渗漏水氮素浓度以及NH+4-N和NO-2-N占TN的比例.控释BB肥和树脂包膜尿素较常规尿素处理水稻全生育期渗漏水TN平均浓度分别降低10.2%和43.3%,TN淋失量分别降低26.1%和39.5%.综上,干湿交替节灌结合树脂包膜尿素施用有利于降低氮素渗漏损失,促进农田面源污染减排.     

Rapid and simple spectrophotometric determination of persulfate in water by microwave assisted decolorization of Methylene Blue

A rapid and simple method for determination of persulfate in aqueous solution was developed. The method is based on the rapid reaction of persulfate with Methylene Blue(MB) via domestic microwave activation, which can promote the activation of persulfate and decolorize MB quickly. The depletion of MB at 644 nm(the maximum absorption wavelength of MB) is in proportion to the increasing concentration of persulfate in aqueous solution. Linear calibration curve was obtained in the range 0–1.5 mmol/L, with a limit of detection of 0.0028 mmol/L. The reaction time is rapid(within 60 sec), which is much shorter than that used for conventional methods. Compared with existing analytical methods, it need not any additives, especially colorful Fe2+, and need not any pretreatment for samples, such as p H adjustment.     

柴油机微粒中可溶性有机成分的真空干燥条件

柴油机碳烟颗粒(PM)中可溶性有机组分(SOF)含量是其重要的特性参数,而真空干燥法可方便、高效、可靠地分析颗粒SOF含量,对其干燥条件的探索具有重要的研究意义和应用价值。首先采用模拟的柴油机颗粒,分析不同的干燥条件对模拟SOF(柴油、润滑油)挥发率的影响规律,得出模拟的SOF分析的最佳干燥条件;在此基础上,探索了真实柴油机颗粒SOF分析的最佳干燥条件为:干燥温度220℃、干燥时间3 h、真空度98 kPa,得知SOF组分干燥的难易程度介于柴油和润滑油之间;同时,根据此干燥条件,分析了排气管末端采集的真实碳烟颗粒的SOF含量特性。     

电渗透脱水对污泥热干燥特性的影响

以污水厂机械脱水后的污泥作为研究对象,提出了采用电渗透-热干燥结合进行深度脱水的方法。通过对原泥以及电渗透脱水至不同含水率(67%、71%和76%)的污泥在热干燥过程中含水率和干燥速率的测定,分析电渗透脱水对污泥热干燥特性的改善规律。结果表明,经电渗透脱水至含水率为67%和71%的污泥在热干燥过程中的传热传质速率及干燥速率有明显提高,且干燥温度越高,电渗透后污泥的干燥速率与原泥的干燥速率差距越大。相同电压梯度及相同温度下电渗透至67%后进行热干燥耗能最少。实际应用中应结合能耗分析选择合适的电渗透程度及干燥温度,以达到最优效果。     

Experimental investigation of a solar water distillation-cum-drying unit

In this communication, a new design of solar-energy-based water distillation cum drying unit with parabolic reflector has been designed, fabricated, and tested. Bitter gourd and potato slices are chosen as a drying commodity. Thermal performance of the developed system has been evaluated based on the experimental results and using linear regression analysis. Heat transfer coefficients (convective, evaporative, and radiative) for solar distillation system have been observed to be 2.48–4.09, 13.25–52.38, and 8.75–9.66 W/m²°C, respectively. Overall thermal efficiency and exergy efficiency for the distillation system has been found to be 18.77% and 1.2%, respectively. The convective heat transfer coefficient for potato slices are observed higher for initial hours and decreases as the day progresses. The average convective heat transfer coefficients for bitter gourd and potato slices have been observed as 2.18 and 5.04 W/m²°C, respectively. Experimental error in terms of percent uncertainty for bitter gourd and potato slices are found to be 42.93% and 37.06%, respectively. The present design of solar distillation and drying in a single unit could be beneficial for the development of remote, arid, and rural areas.     

微波消解-流动注射分光光度法测定土壤中的总磷

采用热效率高的微波消解系统对土壤中的总磷进行消解,建立了微波消解-流动注射分光光度法测定土壤中总磷的方法,该方法对比HJ632-2011碱熔-钼锑抗分光光度法具有快速、简便、节约试剂等特点。本文用两种分析方法对实际土壤样品及标准样品进行定量测定,所得结果表明微波消解法能快速测定大量土壤样品的总磷。     

正交试验-硝酸微波消解-冷原子吸收法测定土壤中汞

应用硝酸微波消解土壤样品-冷原子吸收法测定土壤中的汞。通过正交试验，优化了土壤中汞的微波消解条件。并对干扰消除、方法精密度、加标回收、检出限进行了试验研究。在0～10μg／L范围内线性关系良好，方法测定下限为0．20μg／L，土壤中汞的检出限为0．005μg／g。该优化条件对汞含量为0．02—0．46μg／g的土壤样品，汞提取完全。建立了一种简便、成本低、干扰少、灵敏度高的方法。     

电渗透脱水污泥干燥特性曲线及干燥模型

通过电渗透脱水技术及自然风干技术两种预处理方式降低污泥含水率，当污泥初始含水率相近时，研究经两种方式处理后污泥的干燥特性曲线，并对电渗透脱水污泥干燥特性曲线的优势情况进行探讨。在40—120℃的低温条件下，研究电渗透脱水污泥（泥饼厚度为3．5mm）的干燥特性曲线并分析其干燥特性。通过所得电渗透脱水污泥的干燥特性曲线，引人薄层污泥干燥模型进行数值分析。结果表明，在实验条件下，电渗透脱水污泥的干燥速率要优于自然风干污泥的干燥速率。随着温度的升高，电渗透脱水污泥的干燥速率随之升高，干燥到所需含水率的时间则随之减少。Logarithmic模型比其他模型更适合描述薄层电渗透脱水污泥在低温条件下的干燥特性。